ep

December 30, 2020

Sprockets could be classified into typical sprockets, HK sprockets and various sprockets.
1. Standard sprocket
Normal sprockets are ANSI sprockets which could be engaged with typical series roller chains. See P125 for dimensions.
You will find two kinds of tooth profiles: U-tooth and S-tooth.
two. HK sprocket
HK sprockets can be engaged with HK series roller chains, and these for single strand chains are identical to common sprockets. Nonetheless, sprockets for various strand chains are distinctive from conventional sprockets in sprocket tooth profile.
three. Other sprockets
Other sprockets are built in accordance on the following calculation formulas to suit respective specialty chains.
The sprockets made use of for your following chains will be the very same as the conventional sprockets in tooth gap kind, but unique in tooth thickness (sprocket tooth profile).
4. Calculation of sprocket dimensions
The dimensions of typical sprockets along with other common sprockets are calculated as follows. At first, the diameters of sprockets are calculated through the following calculation formulas.
Next, sprocket tooth profile (the form with the tooth depending on its thickness) is calculated in the following calculation formulas. (The values proven during the following pages have been calculated by these formulas and thought to be the regular values.)
Calculation formulas for diameters and tooth gap types Calculation formulas for diameters
Calculation of pitch diameter, tip diameter and caliper diameter
The fundamental dimensions of a sprocket appropriate for a chain pitch of one mm are respectively termed pitch diameter factor, tip diameter component and caliper diameter component. The respective components for respective numbers of teeth are listed below. If these factors are multiplied by chain pitch, the fundamental dimensions from the corresponding sprocket could be obtained.
Instance:
Inside the situation of 80 (25.40 mm pitch) with 35 teeth Pitch diameter (Dp) = P×Pitch diameter factor
Calculation formulas for tooth gap types
Because the most rational tooth gap kinds in which the strain angle modifications in response on the elongation of a smoothly rotated roller chain using the lapse of support time, ANSI specify two sorts of tooth profiles: U-type and S-type. On the whole, S-type tooth profiles are adopted in accordance with ANSI, and our regular sprockets also have S-tooth profiles.