ep

January 18, 2021

DUMP TRAILER Power UNIT- SINGLE ACTING
Standard Description
This power unit features a electrical power up gravity down circuit. Get started the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve might be offered if required. Also a pressure compen sated movement management may be additional to the circuit to manage the descent velocity with the cylinder.
Remark: Please check with our income engineer for your diverse pump displacement, motor electrical power or tank capacity.
Specific Notes
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean each of the hydraulic components concerned ahead of installation of the power unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is advisable.
four. The power unit really should be mounted horizontally.
five. Check the oil degree while in the tank after the initial operating of your energy unit.
six. Oil modifying is needed after the original a hundred operation hrs, afterwards the moment just about every 3000 hours.

DUMP TRAILER Energy UNIT-DOUBLE ACTING
Standard Description
This electrical power unit features a power up energy down circuit with load holding on both A & B ports. A pressure compensatred movement control could be added to circuit to regulate the decent pace of your cylinder.
Particular Notes
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all of the hydraulic elements concerned in advance of set up of the electrical power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and absolutely free of impurities. N46 hydraulic oil is advised.
four. The electrical power unit should be mounted horizontally.
five. Check the oil level while in the tank immediately after the first working from the power unit.
6. Oil changing is required following the first one hundred operation hrs, afterwards when every 3000 hours.