ep

January 20, 2021

Electrical power UNITS FOR LIFT TABLE one
Standard Description
This energy unit is built solely for that small lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been extensively employed in the industry of logistic units for instance minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled through the solenoid valve with all the pace managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This power unit is made solely for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve along with the speed controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, however the energy provide is cut, the decreasing motion is controlled from the guide override function.
Energy UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is created solely for that substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve and also the velocity controlled by a pressure compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This power unit is created solely to the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve along with the pace controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, but the power provide is lower, the decreasing movement is managed from the guide override perform.
Special Notes
one. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean the many hydraulic components concerned before set up of the power unit.
3. Viscosity of the oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is advisable.
4. Oil modifying is needed just after the first a hundred operation hrs,afterwards after each 3000 hours.
five. The electrical power unit shown is designed to be mounted vertically.