This power unit features a permanent magnet motor using a power up gravity down circuit. Activate the start out solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve with all the decreasing velocity controlled from the strain compensated movement control valve. Solutions of this series might be broadly used in the sector of logistic products this kind of as fork lift, mini lift table, and so on.
1. This energy unit is of S3 duty cycle, i.e.,non-continuous operation, 30 seconds on and 270 seconds off.
2. Clean all of the hydraulic components concerned prior to set up of the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which must also be clean and free of charge of impurities. N46 hydraulic oil is suggested.
four. This power unit is built to be mounted vertically.
five. Check the oil level within the tank immediately after the very first star in the energy unit.
six. Oil altering is required following the original one hundred operation hrs,afterwards the moment each and every 3000 hours.
7. More pump sizes and tank sizes are avaiable upon request.